Quantum AD (Analog to Digital) Conversion System Mounted

WHAT IS THE QUANTIZATION AD CONVERSION SYSTEM?
Up until now, it has not been possible to use the continuous measuring method (used for trace measuring maps etc.) in two or three dimensional digital measurement, owing to the fact that however high the dissolution capacity of the sensor, there was no measuring system that could match it in accuracy. Now with our revolutionary new system, we present a digital measuring, system which can match the dissolution capacity of the sensor in speed and precision, making it equal or better than an analogue system (used in planimeter and map meter measurement). Using this system, measurement can be carried out over one hundred times faster than by using an existing system. Moreover measurement of the area and circumference of a circle, using the continuous measuring method, can be performed so accurately that the only error is that occurring in the tracing. Using an existing system the circle would first have to be divided into a straight-sided shape of 8 to 12 or more unequal sides, and if this was measured several times a big difference would be found in the results obtained from each measurement. The Quantization AD Conversion System can carry out measurement so precisely that the only error is that occurring in the tracing.

The KP-1000 incorporates a digital coordinate measurement system, namely Q-AD conversion system which we uniquely designed. While measuring the area and length of curves, it constantly displays the X-Y coordinate value. Features fast continuity reading of the coordinates of curves which has been deemed impossible by the existing small computers, it is recommended the unit be used as a table top total coordinate measuring device.

POINT MEASUREMENT
Figure consisting of linear lines, as Fig1.
Using the point mode, can be measured simply by indicating the end point of the line. Measuring both the area and length with just one action.

CONTINUITY MEASUREMENT
Figure consisting of irregular curves, as Fig2.
Using the continuity mode and trace the circumference of the figure clockwise measuring both the area and length with just one action.

MIXED MEASUREMENT
Figure consisting of linear lines, irregular curves, and arc lines, as Fig3.
Using the "point mode", "continuity mode" and "arc mode". Measuring can be mixed.

ACCUMULATED MEASUREMENT
Using the [HOLD] key. It can be measure "addition of plural figures" and "measurement of doughnut".

MEMORY FUNCTION
It can be record up to 99 times the accumulated and average data of both the area and length.

UNIT SELECTION FUNCTION
Using the [UNIT] key, selection can be made of either the metric unit (mm,cm,m,km) or the imperial unit (in, ft, acre/yards mi).

SCALE SETTING FUNCTION
Using the [SCALE] key, it can be set separately horizontally and vertically.

CONVERTING THE COORDINATE AXIS FUNCTION
Using the [C,D,M] key and define two points on the X axis, inclination can be corrected.

DATA TRANSFER FUNCTION
The KP-1000 has a function of optical transfer, the data relay by the original interface (PIF) or original printer (PR1), to the computer.